Check for damage
Inspect the packaging on arrival. Photograph any damage, tell the driver and contact us. Do not install a damaged door.
Start by checking your delivery. Then prepare the opening and work with at least two people.
Start with good preparation and a second pair of hands. Here’s what to get ready.
Measure the finished opening. Check that the floor is level and the sides are plumb.
Lift and support the door leaf together. Protect the floor and frame during installation.
Choose fixings suited to your wall and floor. Locate pipes and underfloor heating before drilling.
A question about your opening? Send us a photo and we’ll take a look.
Send us your questionInspect the packaging on arrival. Photograph any damage, tell the driver and contact us. Do not install a damaged door.
Open the packaging carefully without a cutter or sharp knife to avoid damaging the coating or glass.
Hold the steel frame, never the handle or hardware. Do not leave the door leaning unsecured against a wall.
Use cardboard or a soft blanket. Never rest glass or door corners directly on stone, concrete or tiles. Keep the packaging until everything is checked.
The right drill bits and fixings depend on the wall, floor and door system. Check before starting.
This is the general sequence. Exact fixing and adjustment depend on your door system and substrate. Follow the system’s installation instructions.
Determine the position of the upper and lower pivot points.
Check alignment and the substrate before securing the fixings.
Fit the door leaf with at least two people following the system instructions.
Adjust the pivot system and check movement in both directions.
Position the frame in the opening and check it is plumb and level.
Secure the frame with fixings suitable for the substrate.
Hang the leaf in the frame with at least two people.
Check clearances, hinges and the catch. The door should move freely.
Stop before continuing. Take clear photos and contact us. If you are unsure about the substrate or fixings, ask a professional installer.
View service and contact